Avaya FRE-2 Manuel d'utilisateur télécharger pdf (Page 23)

108305 Rev. D

Upgrading the FRE-2 Processor Module

This document describes how to upgrade the Fast Routing Engine-2 (FRE

-2)

processor module memory.

FRE-2 Processor Module Upgrade Procedure

To upgrade a FRE-2 processor module:

Remove the router’s front bezel.

Attach the antistatic wrist strap to your wrist.

Remove the router’s electromagnetic compatibility (EMC) shield.

Remove the FRE-2 processor module you want to upgrade.

Upgrade the FRE-2 processor module.

Reinstall the FRE-2 processor module.

Reassemble the router.

Depending on your router model, you will need a Phillips or standard screwdriver

to replace hardware components.

Removing the Front Bezel

To upgrade the FRE-2 processor module, you must ﬁrst remove it from the router.

You begin by removing the router’s front bezel (front panel) as follows:

Using both hands, pull the bottom of the front bezel forward to remove it

from the router (Figure 1).

Remove the bezel from the chassis.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Pas de commentaire

Avaya FRE-2 Manuel d'utilisateur Page 23