Avaya Configuring XNS Services Manuel d'utilisateur télécharger pdf (Page 56)

Configuring XNS Services

4-20

308651-14.00 Rev 00

Parameter: DLCI (hex)

Path: Configuration Manager > Protocols > XNS > Adjacent Hosts

Default: None

Options: Data Link Control Identifier

Function: Identifies the virtual circuit in a Frame Relay or SMDS network.

Instructions: Enter a locally significant DLCI of up to 16 hexadecimal characters if the

interface is on a Frame Relay or SMDS network.

Leave blank if the interface is not on a Frame Relay or SMDS network.

MIB Object ID: 1.3.6.1.4.1.18.3.5.10.5.1.6

Editing an Adjacent Host

You can edit the configurable parameters of an Adjacent Host entry in the node

configuration. The Configuration Manager does not allow you to change the

Target Host Network and Host ID parameters you set in any Adjacent Host

Configuration window. To establish new values for these parameters, you must

delete that host and configure a new host. You can, however, reconfigure all other

parameters associated with an adjacent host.

To edit the configurable parameters associated with an existing adjacent host,

begin at the Configuration Manager window (refer to Figure 4-1) and select

Protocols > XNS > Adjacent Hosts.

From the XNS Adjacent Hosts window (refer to Figure 4-5):

Select the adjacent host you want to edit. Click on the appropriate entry

in the list of Adjacent Hosts.

Click on any parameter value you want to change; then enter a new

value.

Click on Apply to save your changes.

Click on Done to exit the XNS Adjacent Hosts window.

A description of parameters in the XNS Adjacent Hosts window follows.

Caution:

The router cannot pass traffic through an interface to an adjacent

host on a Frame Relay or SMDS network if the adjacent host is configured

without the correct DLCI.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 71 72

Pas de commentaire

Avaya Configuring XNS Services Manuel d'utilisateur Page 56