Avaya Configuring XNS Services Manuel d'utilisateur télécharger pdf (Page 33)

308651-14.00 Rev 00

3-1

Chapter 3

Enabling XNS Services

This chapter describes how to enable XNS services. It assumes you have read

Configuring and Managing Routers with Site Manager and that you have

1. Opened a configuration file

2. Specified router hardware if this is a local mode configuration file

3. Selected the link or net module connector on which you are enabling XNS

When you enable XNS services, you do not have to configure any XNS

parameters. The Configuration Manager supplies default values for all XNS

parameters. If you want to edit these default values, refer to Chapter 4, “Editing

XNS Parameters.”

Enabling XNS on an Interface

To enable XNS on an interface:

Select XNS from the WAN Protocols menu; this menu appears after you

select a link or net module connector that requires a WAN circuit.

Protocol prioritization is enabled automatically when you select XNS. For

detailed information on protocol prioritization, refer to Configuring Traffic

Filters and Protocol Prioritization.

Click on OK to enable default XNS Services.

The Configuration Manager displays the Select Protocols window. Refer to

the appropriate protocol-specific guide for information on enabling the

protocols you want to run on this interface.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 71 72

Pas de commentaire

Avaya Configuring XNS Services Manuel d'utilisateur Page 33