Avaya Configuring PPP Services Manuel d'utilisateur Page 93

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 140
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 92
Customizing PPP
117360-A Rev. A 3-39
Disabling Loopback Checking
For test purposes, you can disable the loopback test that the peer normally
performs as part of its network integrity checking. The loopback test ensures that
a peer is talking to the network, not to itself.
To disable loopback detection, set the Magic Num Disable parameter to Disable.
After disabling this parameter, you must explicitly set it to Enable to re-enable
loopback checking.
Using the BCC
Navigate to the line prompt for the circuit and enter
magic-number
value
value
is
enable
disable
For example, the following command disables loopback checking on the interface
3/1.
line/3/1# magic-number disable
4. Set Async Control Character Map.
(See page A-26.)
5. If you have no other PPP line parameters
to configure, click on OK. Otherwise,
continue with the Lines configuration.
The Interfaces window opens.
Site Manager Procedure
(continued)
You do this System responds
Vue de la page 92
1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 139 140

Commentaires sur ces manuels

Pas de commentaire