Site Manager Parameters
117355-D Rev 00
A-51
PIM Interface Parameters
Use the following descriptions to set PIM interface parameters.
Parameter: Enable
Path: Configuration Manager > Protocols > IP > PIM > Interface
Default: Enable
Options: Enable
|
Disable
Function: Enables or disables PIM on this interface.
Instructions: After you configure PIM on an interface, PIM is enabled by default. To disable
PIM on this interface without deleting it, enter Disable.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.14.2.1.2
Parameter: Hello Interval
Path: Configuration Manager > Protocols > IP > PIM > Interface
Default: 30
Options: 1 to 2,147,483,647 (seconds)
Function: Specifies how often, in seconds, the local PIM router sends Hello messages on
this PIM interface. PIM routers periodically send Hello messages so that PIM
neighbors can discover each other. Hello messages are multicast using address
224.0.0.13 (all PIM routers group) and are sent on all communication links.
Instructions: Either accept the default value of 30 seconds or set the Hello interval to another
value. Bay Networks recommends a higher number for slower-speed serial
lines.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.14.2.1.8
Commentaires sur ces manuels