Avaya Business Secure Router 252 Configuration - Basics Manuel d'utilisateur télécharger pdf (Page 226)

226 Chapter 13 VPN

NN47923-500

Remote IP Address This field displays the IP addresses of computers on the remote

network behind the remote IPSec router.

This field displays a single (static) IP address when the IP policy's

Remote Address Type field is configured to Single Address in

the IP Policy screen.

This field displays the beginning and ending (static) IP addresses

of a range of computers when the IP policy's Remote Address

Type field is configured to Range Address in the IP Policy

screen.

This field displays a (static) IP address and a subnet mask when

the IP policy's Remote Address Type field is configured to

Subnet Address in the IP Policy screen.

This field displays ALL whenever the Secure Gateway Address

field is set to 0.0.0.0.

This field also displays ALL whenever the IP policy's Remote

Starting IP Address field is set to 0.0.0.0 in the IP Policy screen.

When ALL displays, only the remote IPSec router can initiate the

VPN.

Add Select Add to open a screen where you can configure an IP

policy.

Edit Select the radio button next to an IP policy and then click Edit to

edit that IP policy.

Delete Select the radio button next to an IP policy that you want to

remove and then click Delete.

Authentication

Method

Select the Pre-Shared Key radio button to use a preshared

secret key to identify the Business Secure Router.

Select the Certificate radio button to identify the Business Secure

Router by a certificate.

Pre-Shared Key Type your preshared key in this field. A preshared key identifies a

communicating party during a phase 1 IKE negotiation. It is called

preshared because you must share it with another party before

you can communicate with that party over a secure connection.

Type from 8 to 32 case-sensitive ASCII characters or from 16 to

62 hexadecimal (0-9, A-F) characters. You must precede a

hexadecimal key with a 0x (zero x), which is not counted as part

of the 16 to 62 character range for the key. For example, in

0x0123456789ABCDEF, “0x” denotes that the key is hexadecimal

and “0123456789ABCDEF” is the key itself.

Both ends of the VPN tunnel must use the same preshared key.

You see a “PYLD_MALFORMED” (payload malformed) log if the

same preshared key is not used on both ends.

Retype to Confirm Type your preshared key again in this field.

Table 54 VPN Branch Office rule setup

Label Description

1 2 ... 221 222 223 224 225 226 227 228 229 230 231 ... 459 460

Commentaires sur ces manuels

Pas de commentaire

Avaya Business Secure Router 252 Configuration - Basics Manuel d'utilisateur Page 226

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Avaya Business Secure Router 252 Configuration - Basics