Avaya BCC show Commands for IP Services Manuel d'utilisateur télécharger pdf (Page 16)

BCC show Commands for IP Services

1-2

305755-A Rev 00

show ip adjacent-hosts

The

show ip adjacent-hosts

command displays a table of configured adjacent

hosts. The output includes the following information:

show ip alerts

The

show ip alerts

command displays the circuit name and IP address of

interfaces whose state does not match their configuration, for example, an

interface configured as enabled but whose state is not up. The output includes the

following information:

Host Address IP address of the adjacent host (applies to both single and

expanded).

Interface Address of the IP interface through which packets reach the host.

Encaps Encapsulation method used: ENET (Ethernet), SNAP

(Subnetwork Access Protocol), PDN (Public Data Network), or

DDN (Defense Data Network).

Valid ? Validity of the configuration. If this field displays No, you should

check the adjacent host’s configuration.

State Status of the adjacent host: enabled or disabled.

Mac Address Media access control (MAC) address of the host.

WAN Address Physical address of the adjacent host.

Sub-address Subaddress used to establish a switched virtual circuit (SVC) to

the adjacent host.

Type of Number Type of number used to establish an SVC to the adjacent host.

Circuit Name of the circuit associated with the IP interface.

Circuit # Number of the circuit in the router’s active MIB.

State Status of the IP interface: up or down.

IP Address IP address of the interface.

Mask Subnet mask of the IP interface.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 75 76

Pas de commentaire

Avaya BCC show Commands for IP Services Manuel d'utilisateur Page 16