Avaya 4600 Series IP Telephones Note d'application

Avaya Solution & Interoperability Test Lab Application Notes for Configuring Firetide HotPort 3103 Wireless Mesh Nodes to Support Avaya VoI

4.3. Configure VLAN and VLAN Trunking As mentioned before, Firetide HotPort 3103 Mesh Nodes support VLAN and VLAN Trunking (Carry multiple VLAN in sin

 Repeat the same procedure for fire-tide-2 to add ports 1 and 2 to VLAN 20.  Click Save as shown below. Note the differences between the

Due to the hardware limitations on the Mesh Nodes, port 1 and port 2 must be disabled in order for ports 3 and 4 to be used as trunking ports. Follow

 Select Disable this port for both Port 1 and Port 2.  Click Save. SZ; Reviewed: SPOC 1/24/2006 Solution & Interoperability

To configure Port 3 as a VLAN trunking port, proceed with the following steps.  Open File  VLANs from the Global Configuration Menu screen shown in

 Click Yes from VLAN Trunk warning display. 4.4. Configure Security The Firetide HotPort 3103 Mesh Nodes support two standard security settings

After completing the configuration on a single Mesh Node, the same configuration must be pushed out to the entire meshed network to update other nodes

SZ; Reviewed: SPOC 1/24/2006 Solution & Interoperability Test Lab Application Notes ©2006 Avaya Inc. All Rights Reserved. 17 of 19 Firetide.doc

SZ; Reviewed: SPOC 1/24/2006 Solution & Interoperability Test Lab Application Notes ©2006 Avaya Inc. All Rights Reserved. 18 of 19 Firetide.doc

SZ; Reviewed: SPOC 1/24/2006 Solution & Interoperability Test Lab Application Notes ©2006 Avaya Inc. All Rights Reserved. 19 of 19 Firetide.doc

1. Introduction These Application Notes describe a compliance-tested configuration comprised of Avaya Communication Manager, Avaya IP Wireless Telepho

SZ; Reviewed: SPOC 1/24/2006 Solution & Interoperability Test Lab Application Notes ©2006 Avaya Inc. All Rights Reserved. 3 of 19 Firetide.doc 2

SZ; Reviewed: SPOC 1/24/2006 Solution & Interoperability Test Lab Application Notes ©2006 Avaya Inc. All Rights Reserved. 4 of 19 Firetide.doc •

4. Configure Firetide HotPort 3103 Wireless Mesh Nodes With an auto discovery protocol, the Firetide HotPort 3103 Wireless Mesh Nodes can find each o

The meshed network is shown below. All three Mesh Nodes are linked together via a fully meshed topology. In order to easily identify each Mesh Node, u

Follow the steps below to assign a default gateway to each node.  Click File  Configure Mesh. Figure 2: Global Configuration Menu for Mesh Ne

 Click the Network tab.  Enter 20.1.1.1 for Default Gateway.  Click Save. SZ; Reviewed: SPOC 1/24/2006 Solution & Interope

4.2. Configure Mesh Node Port Property There are four 10/100 switch ports on each Mesh Node and each port can be configured as a 10 or 100 Mbps port w