Avaya HSSI Net Module in an ASN Platform Manuel d'utilisateur télécharger pdf (Page 23)

Installing the HSSI Net Module

117406-A Rev. A

1-7

Figure 1-4. Removing a Net Module from the Connector

Lift the net module bracket up and toward the front of the tray to release

it from the metal tabs that hold it in place (F

igure 1-3).

Installing a Net Module

Before you install a net module, note the following:

• To access position 2 or 4, you must remove the ﬁller bracket and net module

(if any) above it. See the sections “Remo

ving a Filler Bracket” and

“Remo

ving a Net Module” earlier in this chapter.

• To install the net module in the position from which you just removed a net

module, you must ﬁrst delete the old net module from the ASN’s

conﬁguration ﬁle; then, install the new net module in the chassis. See

Conﬁguring and Managing Routers with Site Manager for more information.

To install a net module:

1. Align the slots in the net module bracket with the metal tabs in the net

module position you want to use (F

igure 1-5).

Do not rest the bracket on the metal tabs. Doing so makes it difﬁcult to align

the net module connector with the connector on the ASN system board.

2. Align the net module connector with the connector on the system board.

Make sure that the white retaining post on the system board aligns with

the hole in the net module (F

igure 1-5).

AMC0010A

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 37 38

Pas de commentaire

Avaya HSSI Net Module in an ASN Platform Manuel d'utilisateur Page 23