Avaya Writing Technician Interface Scripts Manuel d'utilisateur télécharger pdf (Page 28)

Writing Technician Interface Scripts

1-14 117382-A Rev. A

Running a Script File

To read and execute the commands in a Technician Interface script ﬁle, and to

ensure that the router deletes all local variables when the script ends, use the

run

command.

For example, to run the script ﬁle test on volume 2, deleting upon script

completion all local variables saved previously to test, enter the following

command:

run 2:test

To locate script errors, use the verbose on command and then use the run

command. The Technician Interface displays each line from the ﬁle before it

executes the line, enabling you to locate errors easily.

You can use the

run command with the -s ﬂag to prevent the system from

returning an error message if the

run command cannot locate the speciﬁed script

ﬁle. The following example shows the

run command with the -s ﬂag:

run -s install.bat

For more information about the run command, see Chapter 2.

Creating Menus

The menu utility allows you to edit existing script menus and to create your own

menus. For instructions on using the menu utility, refer to Using Technician

Interface Scripts.

You can also edit a script menu by directly editing the appropriate .mnu ﬁle.

Appendix A shows examples of a script menu and a script.

Note: The run command automatically appends the .bat sufﬁx to the end of

the script ﬁle name you specify. If you issue the command

run install, the

system ﬁrst looks for a ﬁle named install. If it cannot ﬁnd this ﬁle, it looks for

a ﬁle named install.bat.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 115 116

Pas de commentaire

Avaya Writing Technician Interface Scripts Manuel d'utilisateur Page 28