Avaya Configuring Dial Services Manuel d'utilisateur Page 310

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 482
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 309
Configuring Dial Services
14-2
117353-B Rev. 00
Caller Resolution for Demand Circuit Groups
The router also uses the caller resolution table for demand circuit groups. Demand
circuit groups can only receive calls. For a demand circuit group to accept an
incoming call, you configure the table and assign the demand circuit group to a
remote caller. After the router authorizes a remote caller, it activates a circuit from
the assigned demand circuit group.
Adding Entries to the Caller Resolution Table
For PPP dial-up circuits using CHAP, you should have already set up the caller
resolution table according to the instructions in Chapter 2, “Starting Dial Services
Using Site Manager,” or Chapter 3, “Starting Dial Backup Using the BCC.”
This chapter explains how to modify existing entries in the table and how to add
new ones.
Before you set up your caller resolution table, you should have completed your
dial-on-demand, dial backup, or bandwidth-on-demand configurations.
Using the BCC
This section assumes that you have already created one caller resolution table in
Chapter 3, “Starting Dial Backup Using the BCC.”
For each additional entry, you must create an independent caller-resolution object,
which must include a caller-name.
To add a caller resolution entry, navigate to the backup circuit prompt and enter:
caller-resolution caller-name
<
name_string
>
name-string is a
ny text string; maximum of 20 characters. This name is part of the
incoming call and informs the local router of the remote routers identity.
backup-circuit/8/5/1# caller-resolution caller-name blncorp
You cannot modify an existing caller-name for a caller resolution table entry. You
must delete the entry and create a new one with a new caller name.
After you configure a caller resolution table entry, you can specify either the
CHAP secret or the PAP password, depending on the authentication protocol used
for the backup circuit.
Vue de la page 309
1 2 ... 305 306 307 308 309 310 311 312 313 314 315 ... 481 482

Commentaires sur ces manuels

Pas de commentaire