
Configuring and Troubleshooting Bay Dial VPN Services
5-8 302272-A Rev. 00
tutype
=
tunnel_type
Specifies the type of tunnel to establish.
For a Layer 3 tunnel, specify
dvs
(the
default). For a Layer 2 tunnel, specify
l2tp
.
Required for
add
and
modify
. Not used for other
commands.
pauth
=
primary_authentication_
server_addr
Specifies the IP address of the primary
authentication server. This is usually the
address of the RADIUS server on the
corporate (destination) network.
Required for
add
and
modify
. Not used for other
commands.
sauth
=
secondary_authentication_
server_addr
Specifies the IP address of the
secondary authentication server. You
must not specify a secondary server
without specifying a primary server.
Optional for
add
and
modify
. Not used for other
commands.
pacct
=
primary_accounting_
server_addr
Specifies the IP address of the primary
accounting server. This is usually the
address of the RADIUS server on the
corporate (destination) network.
Required for
add
and
modify
. Not used for other
commands.
sacct
=
secondary_accounting_
server_addr
Specifies the IP address of the
secondary accounting server. You must
not specify a secondary server without
specifying a primary server.
Optional for
add
and
modify
. Not used for other
commands.
paddr
=
primary_dynamic_address_
assignment_server_addr
Specifies the IP address of the primary
dynamic address assignment server.
This is usually the address of the
RADIUS server on the corporate
(destination) network. For DHCP, set
this value to the address of the DHCP
server at the customer site.
Required for
add
and
modify
, but only if the
addrp
argument is not set
to
none
. Not used for
other commands.
saddr
=
secondary_dynamic_address
_assignment_server_addr
Specifies the IP address of the
secondary dynamic address assignment
server. You must not specify a
secondary server without specifying a
primary server.
Optional for
add
and
modify
. Not used for other
commands.
authp
=
authentication_protocol
Specifies the authentication protocol
used between the gateway and the
authentication server. For remote
authentication, this value must be
radius
. For local authentication, this
value can be
acp
.
Required for
add
and
modify
. Not used for other
commands.
(continued)
Table 5-2. tms_dbm Command Arguments
(continued)
Argument Function
Used with These
Commands
Commentaires sur ces manuels