Avaya Managing Routers HTTP Server Manuel d'utilisateur télécharger pdf (Page 19)

Starting and Configuring the HTTP Server

308653-14.00 Rev 00 1-3

When you enable the HTTP Server during the Quick-Start procedure, you can use

the HTTP Server with its default configuration settings after completing the

install.bat procedure. For information on modifying the default HTTP Server

settings, see “C

ustomizing HTTP Parameters.”

After you run the install.bat script, you can install Site Manager software, as

described in Quick-Starting Routers.

Starting the HTTP Server Using the BCC or Site Manager

If you did not use the Quick-Start procedure to start the HTTP Server, you can

start it using the BCC or Site Manager. When you complete this procedure, the

HTTP Server software is configured on the router. Before you start the HTTP

Server, verify that you have configured IP on an interface.

You can start the HTTP Server using default values for all parameters. For

information about modifying the default HTTP Server settings, see “C

ustomizing

HTTP Parameters.”

Using the BCC

Adding the HTTP Server to a router automatically loads TCP on all slots. To add

the HTTP Server to a router, navigate to the box prompt and enter:

http

For example, the following command adds HTTP Server to a router:

box#

http

http#

Note:

For complete instructions on running the install.bat script and verifying

that the installation is successful, see Quick-Starting Routers.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 79 80

Pas de commentaire

Avaya Managing Routers HTTP Server Manuel d'utilisateur Page 19