Avaya Configuring Data Encryption Services Manuel d'utilisateur télécharger pdf (Page 49)

Enabling Encryption

308618-14.00 Rev 00

3-19

Configuring WEP Parameters

WEP has both line and circuit interface parameters. WEP parameters have default

values. To customize WEP for your network, you can edit those values.

Configuring WEP Line Parameters

Enable encryption on this line:

The WEP Enable parameter defaults to Enable when you select WEP from the

Protocols menu. Both the WEP Enable parameter and the PPP or frame relay

Enable parameter must be set to Enable for WEP to function. (Instructions for

setting the Enable parameter for PPP can be found in the section “

Starting

Encryption for PPP” on 3-13. Instructions for setting this parameter for frame

relay can be found in the section “

Starting Encryption for Frame Relay” on

page 3-16

Note:

Enabling WCP adds 5 bytes to the frame’s header. In most cases, this has

no effect on your data, and you do not need to adjust the default configuration. If

you want to increase the maximum transmission unit (MTU) to avoid

fragmenting or dropping large packets, refer to the manual for the WAN protocol

you are using.

Site Manager Path

You do this System responds

1. In the Configuration Manager window,

choose

Protocols

The Protocols menu opens.

2. Choose

WEP

. The WEP menu opens.

3. Choose

Lines

. The WEP Line Parameters window

opens.

4. Set the

Enable

parameter. Click on

Help

or see the parameter description on

page A-4.

5. Click on

Apply

. The WEP Line Parameters window

remains open.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 69 70

Commentaires sur ces manuels

Pas de commentaire

Avaya Configuring Data Encryption Services Manuel d'utilisateur Page 49

Commentaires sur ces manuels

Produits connexes et manuels pour Manuels des logiciels Avaya Configuring Data Encryption Services