Avaya System Memory in a BayStack ARN Router Manuel d'utilisateur télécharger pdf (Page 26)

Installing System Memory in a BayStack ARN Router

1-4

114314 Rev. A

Removing an Installed Memory Module

To remove the existing SIMM from the ARN base module:

Locate the SIMM connector on the ARN base module (Figure 1-4).

Figure 1-4. Location of the SIMM Connector on the Base Module

Note the spring latch at each end of the SIMM connector.

2. Carefully press outward on the two spring latches until the SIMM ejects

from the locking studs (F

igure 1-5).

Apply simultaneous pressure to both spring latches.

SIMM 

connector

ARN0026A

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Avaya System Memory in a BayStack ARN Router Manuel d'utilisateur Page 26