Avaya Configuring MPOA Services Manuel d'utilisateur télécharger pdf (Page 134)

Configuring MPOA and NHRP Services

C-14

309249-14.00 Rev 00

show nhrp interfaces

The

show nhrp interfaces

command displays information about NHRP

interfaces configured on the router. You can control the output of this command by

specifying the following filters in any combination:

Examples:

show nhrp interfaces -enabled

show nhrp interfaces -disabled -pvc

show nhrp interfaces -enabled -service alpha -slot 3

show nhrp interfaces -svc -service beta

show nhrp interfaces -enabled -service beta -slot 4

When you enter this command, with or without filters, the BCC displays the

following information:

-enabled

Displays information only about NHRP

interfaces with a configured state of enabled

-disabled

Displays information only about NHRP

interfaces with a configured state of

disabled

-pvc

Displays NHRP interface information only

for permanent virtual circuits (PVCs)

-service

Displays NHRP interface information for this

service only

-slot

<slot>

[

] [

] Displays information about NHRP interfaces

on this slot and (optionally) connector only.

(Supply a

argument only for ASN

and System 5000 platforms.)

-svc

Displays NHRP interface information for

switched virtual circuits (SVCs) only

Link Protocol The layer 2 protocol used by this NHRP interface (ATM)

Network Protocol The layer 3 protocol used by this NHRP interface (IP)

Packets Tx The number of NHRP packets sent from this interface

Service The unique name assigned to the service record by a user

Slot/Module/Conn The slot (all routers), module (ASN and System 5000 only), and

connector (all routers) associated with this NHRP interface

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 147 148

Commentaires sur ces manuels

Pas de commentaire

Avaya Configuring MPOA Services Manuel d'utilisateur Page 134

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Avaya Configuring MPOA Services