Avaya Configuring Ethernet, FDDI, and Token Ring Services Manuel d'utilisateur Page 63

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 82
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 62
Site Manager Line Services Parameters
117020-A Rev. A A-7
Parameter: BofL Timeout
Path: Configuration Manager > FDDI Connector > Edit Line > Edit FDDI
Parameters
Default: 3 seconds
Options: 0 to 3600 seconds
Function: When BofL is enabled and the link becomes unavailable, this parameter
specifies the time Site Manager waits before disabling the LLC interface.
Instructions: Accept the default value, 3 seconds, or specify a new value. Be sure to set the
BofL Enable parameter to Enable.
MIB Object ID: 1.3.6.1.4.1.18.3.4.4.1.8
Parameter: Hardware Filter
Path: Configuration Manager > FDDI Connector > Edit Line > Edit FDDI
Parameters
Default: Disable (the default changes to Enable when, while adding the circuit , you
reply OK to the prompt
Do you want to enable Hardware Filters on this circuit?)
Options: Enable
| Disable
Function: When you set this parameter to Enable, the link module filtering hardware, if
present, does not allow the router to copy local frames into memory. In essence,
the filtering hardware drops local frames at the interface. Hardware filtering
improves performance because the bridging software no longer uses resources
to receive and reject those frames.
Instructions: Set to Enable only if the link module has hardware filters and you enabled
bridge software.
MIB Object ID: 1.3.6.1.4.1.18.3.4.4.1.37
Vue de la page 62
1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 81 82

Commentaires sur ces manuels

Pas de commentaire