
Page 9
Mapping Switch Console Interface commands to Preside NCS GUI
properties
If you are familiar with the BayStack Console Interface (CI), use the following table to locate the Preside NCS properties that you
want to configure.
Assigning mapping values
NOTE: Nortel Networks does not allow this action
from NCS, because to complete the configuration,
the switch must be reset. If the switch is reset, the
SNMP connection to the switch is dropped. In this
case, export of the configurations is interrupted.
To configure the properties on
this CI Screen...
Select this item in the Preside NCS
navigation pane...
... and choose this
Properties tab
IP Configuration/Setup Switch Basic
SNMP Configuration Switch > SNMP Basic
System Characteristics Switch Import/Export
Switch Configuration > VLAN Configuration
menu > VLAN Configuration
Switch > VLANs folder > VLAN Basic
Switch Configuration > VLAN Configuration
menu > VLAN Port Configuration
Switch > port member of VLAN VLAN
Switch Configuration > VLAN Configuration
menu > VLAN Display by Port
VLANs folder > VLAN Basic
Switch Configuration > Port Configuration Switch > port Basic
Switch Configuration > Multilink Trunk
Configuration
Switch > MLT groups > MLT Basic
Switch Configuration > IGMP Configuration VLAN > IGMP tab and IGMP tab on ports Basic
Switch Configuration > IGMP > port Switch > port IGMP
Spanning Tree Configuration Switch > STG Group > Spanning Tree group Basic
Spanning Tree Configuration > port Switch > port STG
Software Download Switch Image Download Wizard
Switch Configuration > EAPOL Switch > Port EAP
Switch Configuration > MAC Address
Security
Switch MAC Security Basic
Click Task list to return to the list of tasks.
Commentaires sur ces manuels