Avaya Configuring AppleTalk Services Manuel d'utilisateur Page 89

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 128
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 88
Enabling AppleTalk Services
114048 Rev. A 3-9
3.
Enter the appropriate IP address (using dotted decimal notation) in the
Local IP Address field.
4. Click on OK to exit the window and save your changes when you are
finished.
Parameter: Enable
Default: Enable
Options: Enable | Disable
Function: Enables or disables AURP on the router.
Instructions: Set to Enable to globally enable AURP.
MIB Object ID: 1.3.6.1.4.1.18.3.5.4.8.2
Parameter: Local IP Address
Default: None
Options: Any valid 32-bit IP address in dotted decimal notation
Function: Identifies an IP interface on the router. This is the IP interface used for
AURP.
Instructions: Enter the IP address of the interface on this router that AURP should use.
MIB Object ID: 1.3.6.1.4.1.18.3.5.4.8.5
To configure the AURP connection, enter the IP address for the remote peer. To do
this, begin at the Configuration Manager window and proceed as follows:
1. Select Protocols > AppleTalk > AURP > Interfaces.
The AT AURP Interface Configuration window appears (Figure
3-5).
Vue de la page 88
1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 127 128

Commentaires sur ces manuels

Pas de commentaire