Avaya Configuring AppleTalk Services Manuel d'utilisateur Page 101

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 120
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 100
Editing AppleTalk Parameters
117366-A Rev. A 4-15
This reenables the AppleTalk interface and implements your changes to the
zone list.
11. Click on Done to exit the AT Interface Configuration window.
Configuring AppleTalk Zone Filters
This section describes how to add or delete zone filters from an interface’s zone
filter list.
Because the way you configure zone filters may affect your network performance,
refer to the section “Using AppleTalk Zone Filters” in Chapter 2 before
proceeding.
Adding Zones to the Zone Filter List
To add zones to an AppleTalk zone filter list, begin at the Configuration Manager
window (F
igure 4-1):
1. Select Protocols > AppleTalk > Interfaces.
The AT Interface Configuration window appears (F
igure 4-3).
2. Click on Zone Filter.
The AppleTalk Zone Filter Configuration window appears (F
igure 4-5). It lists
the zone filters already configured for the router.
Note: Any changes you make to the zone filter list may not be immediately
apparent to other AppleTalk routers on the network. For example, if you add a
new filter, it may take time for other routers to learn about the new network
information, or to time out the network information that is no longer being
advertised because of the new filter.
Vue de la page 100
1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 119 120

Commentaires sur ces manuels

Pas de commentaire