Avaya an Expansion Module in a BayStack ARN Router (114202 Rev. A) Manuel d'utilisateur télécharger pdf (Page 23)

114202 Rev. A

1-1

Chapter 1

Installing the Expansion Module

Complete the steps in this chapter to install any of the following expansion

modules in an ARN:

• Ethernet

• Token Ring

• Tri-Serial

• Ethernet/Tri-Serial

• Token Ring/Tri-Serial

Although each expansion module type looks slightly different, you install them

identically onto the ARN base module, as follows:

Open the ARN enclosure to access the component tray.

Attach an antistatic wrist strap.

Remove the expansion slot ﬁller panel; or, if present, remove an existing

expansion module.

Install the new expansion module on the ARN base module.

Close the ARN.

Connect network cabling.

Proceed to software conﬁguration tasks.

Caution:

Electrostatic discharge can damage hardware. You must wear the

antistatic strap whenever you remove, install, or handle printed circuit boards.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Pas de commentaire

Avaya an Expansion Module in a BayStack ARN Router (114202 Rev. A) Manuel d'utilisateur Page 23