Avaya 5W Manuel d'utilisateur télécharger pdf

Power

Supply

Telephone

White

Green

-24V DC

Audio Tip

Lead

Color

Function

Black

Red

Ground

(Positive)

Audio Ring

W iring Chart

5W Self-Amplified

Horn Loudspeaker

Description

Issue 1,October 1999

54-2002-01 Printed in USA 9910

Specifications subject to change without notice.

PEC Code: 5328-005

COM Code: 408186005

Model: LU5WSAH

Figure 1

Speaker Installation

This horn loudspeaker is a one-way,self-contained amplified paging horn assembly that incorporates a 5-watt amplifier with a

volume control.This horn may be used to expand the capability of telephone systems in high noise areas,and is suitable for

interior as well as exterior paging applications.

STEP 1 - For easier installation, remove the flange (base) from the speaker by

unscrewing the wing nut while at the same time pressing inwardly on the wing nut (see

Figure 1).Place the flange flush with the mounting surface and mark the location of the

three holes with either a marker or chisel.It is important that the three holes be exact-

ly aligned with the flange,otherwise you might stress the base or make the connection

unsteady.Insert 3 wall anchors - see diagrams on back for drilling instructions and use

of anchors.(Use appropriate hardware for your specific mounting surface.)

STEP 2 - After mounting the flange, reattach the speaker to the flange and aim the

speaker for the desired coverage. A 45

downward angle is recommended, but this

may vary depending upon speaker layout. Unless otherwise indicated, do not aim

speakers directly at each other or poor paging intelligibility may occur.

STEP 3 - Remove the plastic cover to gain access to the volume control. Using the

table to the right and referring to Figure 2 below,make the electrical connection.The

red and green wires are dry loop 600-ohm inputs.Note: Use 22 AWG shielded,twisted

pair on all wire runs. COM Code: 401882956. PEC Code: 2734-SPK. Use a separate cable

for the power and signal connections. Connect the shield of the signal cable to the

ground of the audio source.Do not connect the shield to the speaker (the shield

is only connected at one end).

STEP 4 - Adjust the volume control to the desired setting. Replace the plastic pro-

tective cover back over the exposed area.

White

Black

24V DC

Power Supply

(use only terminals 1 & 2)

Self-Amplified

Horn Loudspeaker

Red

Green

Figure 2

Page 1 of 2

1 2

5W Self-Amplified 1
Horn Loudspeaker 1

Résumé du contenu

Page 1 - Horn Loudspeaker

PowerSupplyTelephone WhiteGreen-24V DCAudio TipLeadColorFunctionBlackRedGround(Positive)Audio RingW iring Chart5W Self-AmplifiedHorn LoudspeakerDescri

Page 2

Using Anchors with Hollow WallsUsing Anchors with Solid WallsDrill 5/16” diameter hole for each anchor and screw.Fold and insert anchor in hole (see F

Commentaires sur ces manuels

Pas de commentaire

Avaya 5W Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Haut-parleurs Avaya 5W. Avaya 5W User's Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels